Coilover question
Thread Starter
Driver School Candidate
Joined: Oct 2013
Posts: 32
Likes: 0
From: AB
Coilover question
I have a set of megan ez street coilovers on my celsior. I'm too low right now and scrape everywhere. Today I adjusted my left side front coilover so that it is 1 inch higher than before, everything went smooth. The problem comes when I go to adjust the right side front coilover higher. I couldnt go higher than half an inch until I can't see the threads from the sight hole. The left side I can still see the threads in the sight hole when I adjusted 1 inch higher than before. The preload on both side is exactly the same. Can anyone give me a suggestion on what's going on? I'm very confused...
there is a chance the front coilover was installed in the back and vice versa on only one side. the front shock bodies are generally shorter.
by the way, most if not all coilovers are NOT meant to be installed right out of the box. they need to lengthened to the proper ride height. they shorten them as much as they could so they fit in the boxes!
by the way, most if not all coilovers are NOT meant to be installed right out of the box. they need to lengthened to the proper ride height. they shorten them as much as they could so they fit in the boxes!
Thread
Thread Starter
Forum
Replies
Last Post
getafewliv
Suspension and Brakes
7
Oct 31, 2014 02:50 PM
GX470GT
LS - 1st and 2nd Gen (1990-2000)
3
Aug 3, 2011 10:09 PM
