Jordanf's UCF10

One of the first things that I did was install a new set of BC coilovers since I couldn't stand the factory ride height.

Set them up for max low right off the bat
It dropped the car wayyy too low for winter and was dragging the exhaust and mudflaps on almost everything

Raised the coilovers a tad



Test fit some wheel I had laying around for fun; 17x10 +25. I'm looking to run 18's in a similar spec but will need to cut the fenders first. I couldn't drop it any further in that pic since the tire was too wide, but i'm positive that they will camber in just perfectly with less tire.



Here is what's done to my car so far:
-Rear windows tinted 20%
-BC coilovers
-Roof spoiler
-UCA clearance holes
-LED interior lights, licence plate lights
-RCR tail lights, clear signals
-6.5" front components, 5.25" rear coax, head unit, sub, amp
Next up will probably be an exhaust tuck and some mufflers.
Then some wide wheels.
-------------------------------------------------------------------------------------------------
This is my summer car that I imported from Japan almost 5 years ago with 66,000 KM
1994 MR2 Turbo SW20
Gen 3 3S-GTE engine


I just bought one as well. 1990, same color as well.
Would you have any more pictures of the 17x10 on the car?
Everyone is saying 17's would be too small but I would like to see otherwise!




