i am having a new headlight housing installed next week after thanksgiving to get rid of my condensation problem. Any suggestions as far as self leveling and the light just bolting right up and in? I was going to do the task myself but their was one bolt i could not reach and i felt like i would need to take off the front bumper. Any comments would be helpful. thanks bryan

 

in order to change the headlight your best bet is to take off the bumper. it will actually be easier and you will do a better job. to adjust the aim of the headlight, read my diy in the information category. you need a 10mm wrench and a wall that's all

 

instruction posted on my website under how to clear out your signal light