Ltaboso

i was wondering if the anyone with hks ssm have the same experience....the axle-back is bolt on,but the flange thats suppose to mate with the oem midpipe seems a little small,so the oem flange and gasket (thick tappered type) won't go in the hks all the way,there's a half inch gap between the 2....is this normal?

Ltaboso

any inputs on this? i just want to know if this is normal...

BucOff

Good question, I wish I had the answer for us both. I have been debating this setup but will hold off until someone else can verify.

Ltaboso

You also installed hks ssm axle-back with stock midpipe?