That eBay listing used my picture but that's not the real diffuser . The listing is fake .
Its not carbon fiber . Stay away from the seller.

 

Is this normal? Ordered the bosal gaskets everyone recommended but they are pretty small in comparison to the Borla flange.

 

That looks to be for the stock size pipe.

 

Yeah but it's bolting up to the stock header so wouldn't that make sense haha? This is the number people bought for their x force systems so figured it would be the same for the Borla.

 

It might work because it will crush when you tighten it. As long as it stays on the header evenly I think it'll be fine. Usually you have to run a 60mm or so gasket to match the piping. There is already a relief for it.

 

Yeah I figured it might crush into that opening. Guess we will find out tomorrow

 

Did you get it installed yet?

 

Your setup looks so nice without being over the top. Is that the Greddy TI exhaust?

 

Thanks , lol wish . It's a borla system with muffler delete and custom tips.

 

Finally got around to installing my Greddy Ti exhaust. Thanks to MIJ for the awesome pricing and letting me aquite this rare exhaust.

 

Not as baller as previous guy but it'll do lol purchased an x-force exhaust and welded eBay tips, I can change out the tips back and forth with the muffler if I needed it to be quiet or vice versa. enjoy the sound clip!

 

Sounds beefy.

 

Finally installed the HPS Rad Hoses today.

 

How are these gaskets holding up?

 

All good thus far. No leaks. Took some finesse to keep them in place while getting the x pipe in place. But they crushed flat and seated just fine.