I have a 2010 is 250. can i get this lip for my car? And if so. where can i get it? Thanks

 

Sewell Lexus parts.

 

So I'm having fittament issues around the passenger side corner.
Checked the forum and it seem that there is a gap on the passenger side.
This gap is annoying! I've seen a few threads though stating to push REAL hard. Ill try this pushing tomorrow.

 

Get under the car (with the proper safety protections in place) and pull on the spoiler near the tab locations. All the tabs should snap together.

 

Success! This front lip is on! With a super hard push on the lip against the bumper those darn gaps disappeared!

 

Good job, and glad it finally fit for ya. I got mine from Sewell a year ago, and did the drilled install. I had the same issue at first, but was able to get mine to flatten out by pressing on it firmly too. If I had seen this thread earlier, I would have chimed in.....

 

Thanks Slammer1. Also didn't drill on my bumper. Just added a little bit more 3m tape. Looks like it will hold.