Pre-Collision system unavailable. HELP

Subscribe
Nov 5, 2023 | 12:19 AM
  #1  
Help. I have a 2016 GSF got about 100345 miles

I recently changed out my front “L” emblem, did not know what went wrong but the pre-collusion system shows unavailable on the dash, and I can't use the cruise control.

There is no code pops up, I clean the sensor and put back to the old emblem, the PCS is still unavailable. Before I changed out the emblem everything was just fine, when the emblem was swapped the PCS was on and off a couple of times until now it has on unavailable. Help, may someone tell me what has to go wrong?
Reply 0
Nov 5, 2023 | 03:38 PM
  #2  
You need to have the code cleared. The problem is since it’s a safety item you can’t just reset the battery.


Steve
Reply 1
Nov 6, 2023 | 10:06 PM
  #3  
I don't think so, my independent body shop forgot to re-attach some cables after painting my bumper, and the safety systems were off line until they reconnected everything once again. No code clearing no nothing.
Reply 0
Nov 9, 2023 | 03:33 PM
  #4  
I will check to see if any code, because the first couple time the PCS is on and off so there is no code.
Reply 0
Nov 9, 2023 | 03:37 PM
  #5  
Quote: I don't think so, my independent body shop forgot to re-attach some cables after painting my bumper, and the safety systems were off line until they reconnected everything once again. No code clearing no nothing.

I just unplug mine when the emblem was removed, I plug it back after I change the emblem, I drove it couple day and then the PCS light pop up, I went back to check the cable, it still plug in, I clean the sensor too, but the PCS light still on.
Reply 0
Subscribe