Led 9005
#1
Driver School Candidate
Thread Starter
Led 9005
Hey guys I purchased the T1 Series from Auxbeam for the 9005 it came with Can Bus Decoders but they were defective I even tried them on a 2012 Odyssey and DRL would only work half the time. I couldn't get them on the phone so i stumbled across a post on here stating you need a cross over harness with a resistor to make everything work. I got that but now the DRL works however the high beams don't work. My question is there any way to keep both functions working With can boxes or do have to scrap the whole idea and stick with halogens? OR can I swap out the 9005 for 9006 and use them in the fog housing with out it being too much glare to other drivers? Thanks
#2
Driver School Candidate
Thread Starter
Edit*** I was able to get the harness to work all I had to do was move the resistor to the passenger side, now I have both the DRL and High Beams working Thanks to iJDMTOY
Thread
Thread Starter
Forum
Replies
Last Post
Lexusblack
RX - 1st Gen (1999-2003)
7
06-13-14 05:49 PM