Rubber vs. polyurethane rear bushing
Thread Starter
Driver School Candidate
Joined: Feb 2011
Posts: 10
Likes: 0
From: CA
Rubber vs. polyurethane rear bushing
Per my earlier posts, I am going ahead with repairs to my 2003 GS300. But I was advised that one of the repairs - replacement of the rear knuckle bushings - cannot be done OEM, because the bushings by themselves are no longer available for my year. I would have to buy the entire knuckle, adding $1,000 to the cost. (I confirmed this with my local Lexus dealership). My mechanic reports he can use non-OEM polyurethane bushings with the existing knuckles. My question to the group is your experience/opinion of using polyurethane bushings vs. OEM rubber bushings? Thanks in advance.
Last edited by gemalter; Aug 16, 2018 at 12:31 PM.
I'm not sure that I've ever seen a poly rear lower knuckle bushing. What I've seen other people install is this Dorman part or others from ebay. If you know of a poly option please link it
Thread Starter
Driver School Candidate
Joined: Feb 2011
Posts: 10
Likes: 0
From: CA
I'm not sure that I've ever seen a poly rear lower knuckle bushing. What I've seen other people install is this Dorman part or others from ebay. If you know of a poly option please link it
Thread
Thread Starter
Forum
Replies
Last Post
Conceptvip
RX - 2nd Gen (2004-2009)
65
Jun 11, 2024 11:53 AM
wnyjazz
LS - 1st and 2nd Gen (1990-2000)
9
May 24, 2022 10:47 AM
