1998 GS300 Remote Programing
Thread Starter
Driver School Candidate
Joined: Dec 2016
Posts: 1
Likes: 0
From: florida
1998 GS300 Remote Programing
I have a 1998 GS300 I am trying to get the remote programed but everytime I do so the locks cycle twice all the locks make the noise to cycle but dont cycle expect for the front driver side. I have replaced all the actulators and I have tryed programing from outside of the car for better signal and nothing.
Anyone have any soultions ?
Anyone have any soultions ?
Intermediate
Joined: May 2014
Posts: 428
Likes: 46
From: WA
If you are programming the remote and when you do part where it asks you to push the buttons, it should cycle once.
If it cycles twice it is rejecting the remote.
You can try deleting all the remotes but you'll need to reprogram all of them individually again.
If it cycles twice it is rejecting the remote.
You can try deleting all the remotes but you'll need to reprogram all of them individually again.
Thread
Thread Starter
Forum
Replies
Last Post
bill4agze
GS - 2nd Gen (1998-2005)
6
Aug 7, 2013 07:53 PM
