Gs400 drive shaft with aristo swap
#1
Driver
Thread Starter
Gs400 drive shaft with aristo swap
I have searched and read a few threads on the gs400 front half not working.
Im curious as to why? Is it just the length?
If if one was to cut the front half down it would work fine correct ?
Guess ss arist swap guys im here to listen.
Im curious as to why? Is it just the length?
If if one was to cut the front half down it would work fine correct ?
Guess ss arist swap guys im here to listen.
#3
Doesnt fit, also the donut is different. I tried the LS400 and its not the same. I have an aristo front half and the dont for sale if youre interested, going manual so I no longer using it
#5
The top shaft in the picture is the one that has to swap. Trans to Mid-mount. The rears are the same.
ive done this swap a few times now, going manual finally on mine.
ive done this swap a few times now, going manual finally on mine.
Last edited by driftdan; 09-26-16 at 10:51 AM.
#6
Driver
Thread Starter
The flange and donut fit. The length is wrong using the gs400 shaft. Going to order an aristo front half and compare them before I install.
Some me said the gs400 would work , well it fits the trans.
It it is too long tho so it does NOT work.
Ill have exact measurements shortly when the aristo half shows up
Some me said the gs400 would work , well it fits the trans.
It it is too long tho so it does NOT work.
Ill have exact measurements shortly when the aristo half shows up
#7
Driver
Thread Starter
Thread
Thread Starter
Forum
Replies
Last Post
RX7 RAGE
Performance & Maintenance
14
03-29-11 09:27 AM
OBEEWON
SC- 1st Gen (1992-2000)
6
01-22-10 02:45 AM
japspec
GS - 2nd Gen (1998-2005)
10
07-30-09 02:17 PM