Clunking noise
Ok so I have replaces both upper and lower ball joints, swat bar end links and bushings, and the outer tie rods. The brake pads don't look like they are moving either. The clunk always comes when I am going slow. I am at a loss. Does anyone have any ideas? And also my headlights don't go out every time after I turn off the car and the switch is on auto.
The only way I know of to check the tranny mount is to take it out, then you might as well replace it. Transmission mounts are cheap like I said before and it takes about 30 minutes even if you have never touched a wrench before, it will be more like an hour if you got rusty bolts and such. Even if the issue was not the tranny mounts, the tranny mount really does improve the ride!
Trending Topics
The only way I know of to check the tranny mount is to take it out, then you might as well replace it. Transmission mounts are cheap like I said before and it takes about 30 minutes even if you have never touched a wrench before, it will be more like an hour if you got rusty bolts and such. Even if the issue was not the tranny mounts, the tranny mount really does improve the ride!
http://www.partsgeek.com/gbproducts/...FZGPPAod208Ayw
This is the place i got mine from, I think...this will fit your 98 Lexus GS. Just out of interest, is yours a GS3 or a GS4?
This is the place i got mine from, I think...this will fit your 98 Lexus GS. Just out of interest, is yours a GS3 or a GS4?
http://www.partsgeek.com/gbproducts/...FZGPPAod208Ayw
This is the place i got mine from, I think...this will fit your 98 Lexus GS. Just out of interest, is yours a GS3 or a GS4?
This is the place i got mine from, I think...this will fit your 98 Lexus GS. Just out of interest, is yours a GS3 or a GS4?
Thread
Thread Starter
Forum
Replies
Last Post
CBMG5
SC - 1st Gen (1992-2000)
4
Jun 21, 2013 10:12 AM





