OK, don't flame me. I have a replica TTE lip and I am trying to mount it. I will add some screws but right now I can't get it to stick. I tried Loctite plastic epoxy (5 of them) and sanded the bumper. I would like some type of epoxy but will I have to do double sided tape? Any tips on attaching this lip or fiberglass lips in general. I want to get it done today so I appreciate any info, thanks.

 

come on, any one got advice?

 

Use masking tape to hold it in place then screw it on. Hope that helps. Let me how they fit, Im thinking of getting one haha. GL

 

I just used the screws and both 3m double side tape and epoxy. Its been holding up well for me.

 

I would say 3m tape and screws. I don't know about the replica would break, but that's how i hold my tte lip.

 

^^^^^^^^ x2

 

^^^^^^^ x3

 

where can i pick up the 3m tape? i went to home depot and only saw the scotch brand

 

Lots and lots of tape to hold it on while it's drying. Theres an epoxy that about every autozone has that they use to put on windshields. USE THAT! Also jam stuff under the lip while its drying tooo.

 

haha damn thats a lot of tape

 

i hate putting the lip on. its so messy. i use silicone and it sticks pretty good. epoxy is one time deal. its hard to get dried epoxy off