Help: Wald kit

Reply Subscribe

Thread Tools

Search this Thread

Jul 21, 2007 | 02:01 PM

dboyz85

Thread Starter

Pole Position

iTrader: (2)

Joined: Jun 2005

Posts: 312

Likes: 0

From: SoCal 714

Help: Wald kit

Hey I was wondering if someone with the wald executive kit can tell me how they fix the rubber molding on the bottom of the doors so it didn't stick out with the side skirts on. Thanks for all your help.

Jul 21, 2007 | 09:41 PM

AristoPra

Lead Lap

iTrader: (10)

Joined: Apr 2006

Posts: 664

Likes: 0

From: CA

Quote:

Originally Posted by dboyz85

i removed them when i realized they were sticking out when the doors closed. hope this helps.

Jul 21, 2007 | 10:13 PM

dboyz85

Thread Starter

Pole Position

iTrader: (2)

Joined: Jun 2005

Posts: 312

Likes: 0

From: SoCal 714

wald kit

How did it look when u removed them? Can u tell that there is a gap between the door and sideskirts? thanks for the help

Jul 22, 2007 | 12:16 AM

Lexus GS3

Trouble Maker

iTrader: (2)

Joined: Oct 2001

Posts: 1,855

Likes: 26

From: *626*California

Quote:

Originally Posted by Lkn4aGS

i removed them when i realized they were sticking out when the doors closed. hope this helps.

how does it look after removing them? GOt a close up picture????? Please post

Jul 22, 2007 | 04:23 AM

DCMango

Lead Lap

Joined: Oct 2005

Posts: 545

Likes: 0

From: Florida

You cannot retain the rubber molding without it looking wired. I have the Sportline kit and I also had to remove the actual molding. How does it look, well it looks normal, nothing out of the blue. You can see a slight difference if you are at eye level where the side skirts start, but other then that, you won't even notice.

Jul 22, 2007 | 04:31 AM

dboyz85

Thread Starter

Pole Position

iTrader: (2)

Joined: Jun 2005

Posts: 312

Likes: 0

From: SoCal 714

kit

Did u also remove the little bit of molding on the front fender and the rear fender too? thanks. and pics please if u have them.

Jul 22, 2007 | 08:59 AM

DCMango

Lead Lap

Joined: Oct 2005

Posts: 545

Likes: 0

From: Florida

Are you talking about the molding that's on the front and rear rocker panel? If so, yes, they should be removed for a perfect visual match. My car ofcourse is in the shop, I will shoot some pictures for you guys tomorrow if no one has done so by then.

Idealy, it will not be wise to leave the molding on the car, not only does it effect the car cosmetically, but the hard rubber molding can also over time scratch the top of the side skirts.

Quote:

Originally Posted by dboyz85

Did u also remove the little bit of molding on the front fender and the rear fender too? thanks. and pics please if u have them.