Nav-system Camera & Mic with Pioneer headunit?
#16
Driver School Candidate
Attachment 474931Attachment 474931
My factory radio receiver connector for the microphone is a 16 pins ( E73), as shown on the attached picture. Just connect pin1 (Mic-), pin2 (Mic+) of E73 to my after-market radio receiver microphone cable. And connect +5vdc power to pin7 (Mcvd). That's it! And I just enjoy the original factory microphone nicely! No picture for the setup, sorry and good luck...!
My factory radio receiver connector for the microphone is a 16 pins ( E73), as shown on the attached picture. Just connect pin1 (Mic-), pin2 (Mic+) of E73 to my after-market radio receiver microphone cable. And connect +5vdc power to pin7 (Mcvd). That's it! And I just enjoy the original factory microphone nicely! No picture for the setup, sorry and good luck...!
#17
Driver School Candidate
"I'm connecting PIN 1 and PIN 2 to the microphone cable that plugs into my stereo unit."
Just swapping Pin1 (-) and Pin2(+) to see if it work. Make sure pin 7 has +5VDC.
It has been a long time to remember, but it work for me. Sorry and good luck to you!
Just swapping Pin1 (-) and Pin2(+) to see if it work. Make sure pin 7 has +5VDC.
It has been a long time to remember, but it work for me. Sorry and good luck to you!
The following users liked this post:
Rerun (11-15-19)
Thread
Thread Starter
Forum
Replies
Last Post