When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Every couple of weeks the "check engine" light in my '98 ES300 (193K miles)comes on, and my code reader indicates P0440. I know it is something in the EVAP system. I replaced the original gas cap with a new OEM cap, but no change. I do know that there is no pressure release when I loosen the gas cap during a fill-up. So I suspect that I have a loose vacuum hose or my charcoal canister is bad. My questions are:
Is there a vaccum hose which is more prone to leaking or coming loose? If so, where does it come from and where does it go to?
or you could have the evap solenoid failing. the best and really only way to test it is to have the factory scan tool to open and close the evap solenoid while you pressurize the evap system with a nitrogen and smoke mixture while you look for leaks. any one of the vacuum lines could be leaking, the canister could be leaking, the gas tank seals could be leaking, etc.
I will give you a list, but usually I have seen the charcoanl cannister being the issue.
Charcoal canister (cracked, damaged)
Fuel tank (not likely)
Hose or tube on route to charcoal canister (often a line that goes over the fuel tank)
vacuum hose (cracked damaged) can happen in the engine bay
fuel cap
vapor pressure sensor