Notices
Build Threads Details on Club Lexus RC-F owner vehicles

Keoni - Nebula Grey 2015 Build

Thread Tools
 
Search this Thread
 
Old Feb 19, 2020 | 07:17 PM
  #31  
weswork's Avatar
weswork
Intermediate
20 Year Member
Photogenic
Photoriffic
Liked
iTrader: (4)
 
Joined: May 2005
Posts: 427
Likes: 84
From: NC
Default

Originally Posted by tuscani66
Finally finished my steering wheel, CF on button surrounds on, now the wheel is complete!
Really like that steering wheel with the LEDs. Hard to install connectors to get it to feed the data? Who is the source of the wheel and cost? Sorry if mentioned earlier in the thread.
Reply
Old Feb 20, 2020 | 07:26 PM
  #32  
tuscani66's Avatar
tuscani66
Thread Starter
Pit Crew
iTrader: (2)
 
Joined: Feb 2018
Posts: 235
Likes: 79
From: PGH PA / ATL GA
Default

Originally Posted by weswork
Really like that steering wheel with the LEDs. Hard to install connectors to get it to feed the data? Who is the source of the wheel and cost? Sorry if mentioned earlier in the thread.
Wasn't hard at all, source is OBD2 fed (splitter cable) to module and module is Bluetooth (as is steering wheel, aside from natural delay BT has, it feels/looks seamless as if it wasn't wireless). Power through one of the button switches for simplicity but the switches only power up when headlights/parking lights are on... I'm still unsure if I'm going to take the time to change my power source (run it through the hub and steering column) because I was originally going to be satisfied with a CF flat bottom wheel and now this has LCD (timer, countdown, lap, RPM, MPH/KMH, and the side LEDs are programmable to the RPM you want them to respond to) so its like a bonus and not sure if I will go through the trouble.

As far as cost, I bought it from Ali-Express, I can't remember the exact cost and will have to look it up when I get home (work travel at the moment) and check my documentation binder for receipts... it was less than 1000$ USD range shipped. Took about a week or 10 days at most.
Reply
Old Jul 29, 2020 | 01:54 PM
  #33  
tuscani66's Avatar
tuscani66
Thread Starter
Pit Crew
iTrader: (2)
 
Joined: Feb 2018
Posts: 235
Likes: 79
From: PGH PA / ATL GA
Default

Installed the CF intake with burnt clamps, K&N filter and OEM cabin filter, gave her a wash.

Reply
Old Aug 2, 2020 | 08:59 PM
  #34  
Mingofish's Avatar
Mingofish
Lexus Test Driver
 
Joined: Jul 2016
Posts: 870
Likes: 333
From: Ga
Default

Spotless!!
like the burnt clamps.
Reply
Old Aug 7, 2020 | 10:36 AM
  #35  
tuscani66's Avatar
tuscani66
Thread Starter
Pit Crew
iTrader: (2)
 
Joined: Feb 2018
Posts: 235
Likes: 79
From: PGH PA / ATL GA
Default

Lowered the front using Swift Springs - I like the look but really hope it doesn't settle too much!

Before:


After:


Reply
Old Sep 27, 2020 | 04:49 PM
  #36  
tuscani66's Avatar
tuscani66
Thread Starter
Pit Crew
iTrader: (2)
 
Joined: Feb 2018
Posts: 235
Likes: 79
From: PGH PA / ATL GA
Default

Got the hood partially painted body color, reclear whole hood (and recleared the fender CF piece and rear bumper flare CF pieces too while I was at it).


Reply
Old Dec 22, 2020 | 10:31 AM
  #37  
tuscani66's Avatar
tuscani66
Thread Starter
Pit Crew
iTrader: (2)
 
Joined: Feb 2018
Posts: 235
Likes: 79
From: PGH PA / ATL GA
Default

Programmed new key card, used Hybrid version so that the "L" is blue, had to order the F for sensor cover as well.


Also installed remote start as a Christmas Present, should have done a walkthrough but I had it installed in 10 minutes and that included programming - its pretty straight forward. Uses OEM key fob, 3X lock press to start or stop, works like Inform did so when you touch the door to open it the car shuts off.
Reply
Old Jan 4, 2021 | 08:53 AM
  #38  
1A1's Avatar
1A1
Instructor
10 Year Member
Liked
Loved
Community Favorite
 
Joined: Aug 2011
Posts: 917
Likes: 322
From: IN
Default

You lowered just the front? How does it feel - handling wise? I'd think the different spring rates may throw things off.

Steve
Reply
Old Jan 4, 2021 | 09:11 AM
  #39  
tuscani66's Avatar
tuscani66
Thread Starter
Pit Crew
iTrader: (2)
 
Joined: Feb 2018
Posts: 235
Likes: 79
From: PGH PA / ATL GA
Default

After almost 18 months of collecting/sourcing my 'lip' kit, as I did not go with a single brand for uniformity, I did however wait till I had everything because I did not want to put my car piece by piece and just put all on at once. On the 3rd of January Lexus had a section in our local Caffeine & Octane and I was able to secure one of the 30 spots so it pushed me to install.

Front lip, sides, rear OEM bumper insert (and the reflectors switched to LED sweeping/sequential with stop and turn signals - and smoked them) and rear diffuser.







I have the roof spoiler on the way but I can install that later and I also have the M3/4 style mirror caps (for over a year haha) but still unsure of how I feel of them - will have to install to really determine or not. All parts are CF as I apparently still have an obsession over it even after 20 years...

Reply
Old Jan 7, 2021 | 07:28 PM
  #40  
tuscani66's Avatar
tuscani66
Thread Starter
Pit Crew
iTrader: (2)
 
Joined: Feb 2018
Posts: 235
Likes: 79
From: PGH PA / ATL GA
Default

Wanted to post how I did my bumper LED inserts, raerae1616 had a great write up HERE but I did a few personal changes myself:







1. I bought 18/4 wire male/female connectors that are water tight for quick disconnect and mounted it right next to the parking sensor disconnect.
2. bought 18/4 wire, single sheath, and soldered both ends.
3. ran a single 18ga wire from right signal bulb (green/white wire) to the driver side safely and out the quarter panel grommet.
4. I did not use the bumper LED 'white' wire because I did not want them on unless I was either braking or turn signal.



Last edited by tuscani66; Jan 7, 2021 at 07:33 PM.
Reply
Old May 8, 2022 | 09:06 AM
  #41  
tuscani66's Avatar
tuscani66
Thread Starter
Pit Crew
iTrader: (2)
 
Joined: Feb 2018
Posts: 235
Likes: 79
From: PGH PA / ATL GA
Default

New Forge 3-Piece wheels and tires!



Reply
Old May 9, 2022 | 09:34 PM
  #42  
IntrinoX's Avatar
IntrinoX
Racer
5 Year Member
Liked
Loved
Community Favorite
iTrader: (1)
 
Joined: Nov 2017
Posts: 1,291
Likes: 617
Default

Originally Posted by tuscani66
Programmed new key card, used Hybrid version so that the "L" is blue, had to order the F for sensor cover as well.


Also installed remote start as a Christmas Present, should have done a walkthrough but I had it installed in 10 minutes and that included programming - its pretty straight forward. Uses OEM key fob, 3X lock press to start or stop, works like Inform did so when you touch the door to open it the car shuts off.
Did this hybrid version program to your car okay? I know these transmitters get very picky when programming. I like the blue hybrid hue.
Reply
Old May 10, 2022 | 01:04 AM
  #43  
tuscani66's Avatar
tuscani66
Thread Starter
Pit Crew
iTrader: (2)
 
Joined: Feb 2018
Posts: 235
Likes: 79
From: PGH PA / ATL GA
Default

Originally Posted by itsraysgs
Did this hybrid version program to your car okay? I know these transmitters get very picky when programming. I like the blue hybrid hue.
The 'hybrid' key is no different than any other, with that said, programming worked just fine. I wanted this Hybrid key for the sole reason that the "L" is surrounded in blue to mimic in a way our "F" is.
Reply
Old May 12, 2022 | 10:24 AM
  #44  
IntrinoX's Avatar
IntrinoX
Racer
5 Year Member
Liked
Loved
Community Favorite
iTrader: (1)
 
Joined: Nov 2017
Posts: 1,291
Likes: 617
Default

Originally Posted by tuscani66
The 'hybrid' key is no different than any other, with that said, programming worked just fine. I wanted this Hybrid key for the sole reason that the "L" is surrounded in blue to mimic in a way our "F" is.
Do you have a part number handy?
Reply
Old May 16, 2022 | 10:39 PM
  #45  
IntrinoX's Avatar
IntrinoX
Racer
5 Year Member
Liked
Loved
Community Favorite
iTrader: (1)
 
Joined: Nov 2017
Posts: 1,291
Likes: 617
Default

Originally Posted by tuscani66
The 'hybrid' key is no different than any other, with that said, programming worked just fine. I wanted this Hybrid key for the sole reason that the "L" is surrounded in blue to mimic in a way our "F" is.
have a part number handy?
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
keiusui
RC F (2015-present)
1
Sep 24, 2014 08:35 PM
2jzpwr808
IS - 2nd Gen (2006-2013)
5
Apr 12, 2014 10:04 PM
J1 IS300
IS - 1st Gen (2001-2005)
6
Jan 2, 2005 07:27 PM




All times are GMT -7. The time now is 12:13 AM.