help! Broken oxygen sensor connector (female end, Bank 1 sensor 2)
#1
Driver School Candidate
Thread Starter
Join Date: Dec 2012
Location: NY
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
help! Broken oxygen sensor connector (female end, Bank 1 sensor 2)
My oxygen sensor (bank 1 sensor 2 ) connector (female connector, engine/ecu side) is cracked and the wires pulled out. I tried to source this from a junkyard but no one around me (LI, NY) seems to have the car.
Any ideas on where I can get a replacement connector to splice in?
Any ideas on where I can get a replacement connector to splice in?
#3
Driver School Candidate
Thread Starter
Join Date: Dec 2012
Location: NY
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
#4
It's just the plastic housing. You should be able to remove the pins from your old connector and reuse them if they are undamaged. If you need them, 82998-12440 is the part number for the wires with the female pins on the end of them for that connector, but you would need four of them and they're each almost as expensive as the plastic connector.
#5
Driver School Candidate
Join Date: Oct 2017
Location: Texas
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
It's just the plastic housing. You should be able to remove the pins from your old connector and reuse them if they are undamaged. If you need them, 82998-12440 is the part number for the wires with the female pins on the end of them for that connector, but you would need four of them and they're each almost as expensive as the plastic connector.
#6
My oxygen sensor (bank 1 sensor 2 ) connector (female connector, engine/ecu side) is cracked and the wires pulled out. I tried to source this from a junkyard but no one around me (LI, NY) seems to have the car.
Any ideas on where I can get a replacement connector to splice in?
Any ideas on where I can get a replacement connector to splice in?
Thread
Thread Starter
Forum
Replies
Last Post