Turn Signals Not Working
#1
Driver School Candidate
Thread Starter
Join Date: May 2004
Location: Texas
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
Turn Signals Not Working
I've recently acquired a 2000 LS400 from my father. Upon picking it up I immediately noticed the fast signal indicating burnt out bulbs for both left and right. It turns out all the signal bulbs were out. I only had one bulb in the garage and replaced a rear bulb and it worked (but I still got the fast blink as the remaining three corners were out). I bought some new bulbs, replaced the remaining three corners and now...nothing. Not even a fast blink. I can't even get the Hazard lights to activate with the center stack button. I checked the #1 and #19 fuses and they're fine.
Anyone had this problem?
Anyone had this problem?
#5
Driver School Candidate
Thread Starter
Join Date: May 2004
Location: Texas
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
Still no blinking. I found where the flasher is, removed it and called around looking for one. Only from the dealer for $60. The parts guy did tell me everything routes through the hazard switch on the dash as well and I noticed that the hazard button is not illuminated at all. So, perhaps its the switch and not the flasher. Does anyone know if the flasher supplies power to the hazard switch or vice versa?
#7
Driver School Candidate
Thread Starter
Join Date: May 2004
Location: Texas
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
Well, I already checked the #1 and #19 fuses, those are the only two listed in the manual having to do with the signals. Are there others not listed in the manual I should check?
Trending Topics
#8
Driver School Candidate
Thread Starter
Join Date: May 2004
Location: Texas
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
Does this fuse look blown to anyone? Well it is. #33 fuse in the engine compartment fuse block. Hairline break Blinkers now working.
Anyone need a brand new flasher relay?
Anyone need a brand new flasher relay?
Thread
Thread Starter
Forum
Replies
Last Post