HELP! My fog lights fuse keep blow?
#1
HELP! My fog lights fuse keep blow?
Hi everyone, I have problem with my fog lights lately for some reason the fuse keep blow, I took every thing apart and put together, but no luck (it never happen before) I gave up and low the car down from the jack stands, and put the new fuse in, and it ok again and I drive for few days, and when I drive through some of the rough roads and the fuse burn again and last night I took every thing off again and test the ballasts on different battery and they are work like normal, and I install back on my car and replace the new fuse, when I turn on the light the fuse fire again do you guys think any it has to do to the rear afs sensor? reason I ask is when I jack the front car up and turn on the light, and the fog lights fuse blow? when I low the car down it work like normal? but now even the car on the jack or off the jack the fuse keep blow please help
#4
#6
my fogs were blowing my fuses too. It turned out to be a bad ballast.
replaced the ballast and now all is good.
might just be a loose connection so sometimes it works and sometimes it blows the fuse.
replaced the ballast and now all is good.
might just be a loose connection so sometimes it works and sometimes it blows the fuse.
Trending Topics
#8
yep. the reason is because oem ballasts draws more power than aftermarket hid kits at initial startup. thus, i believe the best solution is to get an relay and draw power directly from the battery. and oem ballasts last forever :]
#9
thanks, but I run the denso ballasts before switch to nissan ballasts and run for about three months without any issues? and I retrofit my 08 camry to rx330 projectors and run denso ballasts for months without relay harness with no problem? I don't know why on my fog like that
Thread
Thread Starter
Forum
Replies
Last Post