Erreur code C1336 GX470 '05
#1
Driver School Candidate
Thread Starter
Join Date: Apr 2014
Location: illinois
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
Erreur code C1336 GX470 '05
Hi Team,
I used Maxidas for scanning my GX470 05 and i have bellow erreur code.
C1336
Somebody knows how to resolve it ?
Thank You for your support
I used Maxidas for scanning my GX470 05 and i have bellow erreur code.
C1336
Somebody knows how to resolve it ?
Thank You for your support
#2
Lexus Champion
C1336/39
-Zero point calibration of deceleration sensor undone
-Yaw rate and deceleration sensor
-Zero point calibration undone
-Park/Neutral position switch (P position) circuit
See attached PDF....
-Zero point calibration of deceleration sensor undone
-Yaw rate and deceleration sensor
-Zero point calibration undone
-Park/Neutral position switch (P position) circuit
See attached PDF....
#4
The Zero Point Calibration is only done under following circumstance.
1. Wheel Alignment has been adjusted
2. Any chassis component has been removed, installed or replaced
Basic Method
Disconnect the cable from the negative (–) battery terminal for MORE THAN two (2) seconds.
2. Reconnect the cable to the negative (–) battery terminal.
3. Perform the applicable zero point calibration of the yaw rate sensor and/or the steering angle
sensor. ( rotate Steering to the Left extreme and hold for 3 Seconds and then rotate to Extreme Right 3 Seconds and do this method for 3 cycle repeatedly.
1. Wheel Alignment has been adjusted
2. Any chassis component has been removed, installed or replaced
Basic Method
Disconnect the cable from the negative (–) battery terminal for MORE THAN two (2) seconds.
2. Reconnect the cable to the negative (–) battery terminal.
3. Perform the applicable zero point calibration of the yaw rate sensor and/or the steering angle
sensor. ( rotate Steering to the Left extreme and hold for 3 Seconds and then rotate to Extreme Right 3 Seconds and do this method for 3 cycle repeatedly.
#5
The Zero Point Calibration Method if the basis one fails to solves . Check the attachment. Only you need to have the tool ( these are available off Amazon, Ebay for $30-50)
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post