Go Back   Club Lexus Forums > Lexus Model Forums > ES Models > ES350 (2007 - 2012)
Sign in using an external account
Register Forgot Password?

Bumper/Headlight removal (pics inside)

Reply
 
 
 
 
Thread Tools Search this Thread Display Modes
Old 07-31-12, 09:57 AM   #1
carcass29
Rookie
Trader Score: (0)
 
Join Date: Sep 2008
Location: New York
Posts: 68
Default Bumper/Headlight removal (pics inside)

Just wanted to cover this if anybody was curious on how to do this themselves....pretty easy to do. Tools needed:
10 mm ratchet
Phillips head screwdriver
Flathead screwdriver


Click the image to open in full size.
Click the image to open in full size.
Click the image to open in full size.
Click the image to open in full size.
Click the image to open in full size.




-first remove all engine cover clips using flathead screwdriver or fingernail by pressing down in the center of caps (remove all 3 covers)

- starting at wheel well with your ratchet(underneath) start removing bolts at the bottom of vehicle.....between the bumper and lower plastic shielding, there are 5 bolts total...you will end at the opposite wheelwell on other side of car.

-next, start vehicle and turn steering wheel sharp left or right depending on which side you are working....this allows space to get at bolts inside wheelwell.

-take your flathead and you will see 2 oversized plastic screws at the lower edge of wheelwell where bumper connects with inner shielding...quarter turn and grab with fingers and remove.

-above the area mentioned last above(large plastc screws) where bumper meets fender, pull back plastic shielding slightly to reveal bolt that will be removed next(this bolt keeps the corner edge of the bumper in place with the fender) use ratchet

-the lower portion of the car is complete.

-next you will be above the vehicle standing over the grill section removing two large bolts wrapped in rubber using your phillipshead they are located at both ends of the grill...there are also a few plastic clips that have to be removed also holding the bumper in place.

-next with your ratchet, behind the grill... you will see 3 bolts one left, one center, one right.

-grab bumper with both hands and give a shake and with a little force the bumper will disconnect from body of car.

-the bumper is almost done....balance the bumper on knees because there is one more step....foglights. disconnect the lights by turning the bulb because the bumper will not touch the ground until this step is done...you can disconnect the bulb at wiring harness or turn the bulb and remove which i find easier. and Voila!


-Headlight removal- very simple process! 4 bolts total
use ratchet....two at the very top...you will see the clips. you can't miss them.....next one is to right/left of headlight, where the headlight turns into pointy edge. Next the hidden one! where the fender remains there is a black plastic bracket which holds the bumper in place... look inside the plastic squares you will see the final bolt. Thats it! grab the headlight assembly and shake and pull until it slides outward. Almost done....all lighting clips have to be removed for the headlight to be removed completely... ie Hid, parking lights...etc etc. same thing as the fogs in previous step.


Hope this helps any of you DIY guys out there....good luck
This ad is not displayed to registered members.
Register your free account today and become a member on Club Lexus!
carcass29 is offline   Reply With Quote
Old 07-31-12, 03:25 PM   #2
dman00001
Rookie
Trader Score: (0)
 
Join Date: Dec 2010
Location: GA
Posts: 83
Default

Great stuff, thanks!
dman00001 is offline   Reply With Quote
Old 07-31-12, 03:25 PM
 
 
 
 
Reply

Similar Threads
Thread Thread Starter Forum Replies Last Post
RX300: DIY door lock actuator fix write-up 2002RX300 RX - First Generation 195 12-11-14 07:01 PM
Cargo Hatch Switch Replacement How-To with Pics defo RX - Second Generation 17 10-24-14 11:11 AM
DIY Rear GFX (Cutting Method) T4styPh0 IS - Second Generation 59 07-21-13 07:17 PM
Chrome Trim DIY update carcass29 ES350 (2007 - 2012) 5 02-25-13 05:46 AM
White Lexus ES 350 ...now with Pinstripes carcass29 ES350 (2007 - 2012) 12 05-09-09 07:06 PM


Tags
2007, 350, bumper, diy, es350, gs, gs350, harness, headlight, is350, lexus, picture, removal, remove, replacement

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

Forum Jump

All times are GMT -7. The time now is 12:47 AM.

Join ClubLexus
Advertising


Copyright © 2000-2008 Internet Brands, Inc. All Rights Reserved
Privacy Policy | Disclaimer | Terms of Use | JOBS


Get all contact info