CAN-Other FS: SSR Werfen GT-03 w/tires and TPMS
#1
FS: SSR Werfen GT-03 w/tires and TPMS
These came off of my 2008 IS250 AWD. I bought them from another member here on ClubLexus earlier this summer, and they have seen about 6000 kms (3700 miles). Half of this was from a very recent trip from Manitoba to Alberta and back. There is a patch in the rear passenger tire from a screw that was picked up about a month after I mounted the tires to the wheels. That being said, I did not encounter any issues during my road trip, when I was travelling at speeds up to 150km/hr, and the tire holds air no problem. There are also a few very minor rock dings from the highway, and some light scratching on the lips. Nothing that can't be professionally polished out. Here are some pics from a recent photoshoot in October.
SSR Werfen GT-03 (http://www.ssr-wheels.com/wheels/werfen_181920.asp)
MSRP of $4080, not including taxes/shipping/duties. You can visit the link to verify, but nobody pays MSRP anyway lol.
This is a 3-piece wheel; the face can be unbolted and removed. The outer lip and inner barrel are welded together. The inner barrel is "heat treatment manufactured" (HTM) for extra strength and reduced weight.
PCD: 5x114.3, hub size will fit most Lexus and Toyota, not sure about others.
Front: 19x8 +37, 42mm lip
Rear: 19x10.5 +43, 67mm lip
235/35 Fuzion ZRi, tread life to be measured, even wear
275/30 Fuzion ZRi, tread life to be measured, even wear, one patch in one tire
The tires are one season old, and were purchased through Phil at Fast Toys (a local vendor). I still have the receipt totaling $590ish for the tires (will clarify exact purchase price tomorrow).
The faces were powdercoated anthracite silver by the previous owner just before they were sold to me.
The sale will include the following:
SSR centre caps ($180)
SSR license plate frame ($10)
Two 5mm generic spacers (never used) ($20)
4 SSR valve stem extensions ($30)
4 OEM Lexus IS250 TPMS sensors ($150)
Set of 16 SSR lug nuts ($125)
Snd a set of 20 spline drive Gorilla lug nuts ($20)
$1500 OBO +shipping.. I'd like to sell as a set since shipping tires and wheels separately across the border would be way too expensive for me to make it worthwhile.
I like the wheels, and if they don't sell, I'll continue to run them. I think I just want to switch it up a bit. I did plan on getting the barrels cleaned up and refinished (inner and outer rim) over the winter, but I have yet to get a quote. I have to pull the wheels out to wipe them down a bit, so I'll take pictures when I do that and update the thread accordingly.
ALL PRICES ARE IN CAD, please take that into account. I have also lowered my original asking price from my local selling price of $1700 to make it more "attractive" for any US buyers.
PM if you have questions please.
** EDIT: Forgot to state that that lug nuts in the pics I used were NOT the SSR lugs, they were the Gorilla lugs. The SSR lugs are brand new in their packaging. They just happened to be in my car, so here they are pictured with the generic spacers:
I only ordered 16 because I had planned to use a set of wheel locks with the lugs, but never ended up putting them on.
SSR Werfen GT-03 (http://www.ssr-wheels.com/wheels/werfen_181920.asp)
MSRP of $4080, not including taxes/shipping/duties. You can visit the link to verify, but nobody pays MSRP anyway lol.
This is a 3-piece wheel; the face can be unbolted and removed. The outer lip and inner barrel are welded together. The inner barrel is "heat treatment manufactured" (HTM) for extra strength and reduced weight.
PCD: 5x114.3, hub size will fit most Lexus and Toyota, not sure about others.
Front: 19x8 +37, 42mm lip
Rear: 19x10.5 +43, 67mm lip
235/35 Fuzion ZRi, tread life to be measured, even wear
275/30 Fuzion ZRi, tread life to be measured, even wear, one patch in one tire
The tires are one season old, and were purchased through Phil at Fast Toys (a local vendor). I still have the receipt totaling $590ish for the tires (will clarify exact purchase price tomorrow).
The faces were powdercoated anthracite silver by the previous owner just before they were sold to me.
The sale will include the following:
SSR centre caps ($180)
SSR license plate frame ($10)
Two 5mm generic spacers (never used) ($20)
4 SSR valve stem extensions ($30)
4 OEM Lexus IS250 TPMS sensors ($150)
Set of 16 SSR lug nuts ($125)
Snd a set of 20 spline drive Gorilla lug nuts ($20)
$1500 OBO +shipping.. I'd like to sell as a set since shipping tires and wheels separately across the border would be way too expensive for me to make it worthwhile.
I like the wheels, and if they don't sell, I'll continue to run them. I think I just want to switch it up a bit. I did plan on getting the barrels cleaned up and refinished (inner and outer rim) over the winter, but I have yet to get a quote. I have to pull the wheels out to wipe them down a bit, so I'll take pictures when I do that and update the thread accordingly.
ALL PRICES ARE IN CAD, please take that into account. I have also lowered my original asking price from my local selling price of $1700 to make it more "attractive" for any US buyers.
PM if you have questions please.
** EDIT: Forgot to state that that lug nuts in the pics I used were NOT the SSR lugs, they were the Gorilla lugs. The SSR lugs are brand new in their packaging. They just happened to be in my car, so here they are pictured with the generic spacers:
I only ordered 16 because I had planned to use a set of wheel locks with the lugs, but never ended up putting them on.
Last edited by sm1ke; 11-01-13 at 02:20 PM.
Thread
Thread Starter
Forum
Replies
Last Post
acuteperformance
Club Lexus Vendor Marketplace
17
09-26-13 09:01 AM
kelzzz
Wheels and Tires Classifieds
12
12-03-11 01:08 PM