What else should I replace while doing control arms?
#1
Rookie
Thread Starter
What else should I replace while doing control arms?
Yet another suspension thread....
Tons and tons of info about control arms, not going to go into that. Mine need replacing, and I just bought a new set of tires I don't want to wear out prematurely... tires are expensive So, what all should I replace while I'm in there?
I'm thinking:
FRONT
Upper control arms
Lower control arms
Tie rod ends
Steering rack bushings (recently did these, amazing difference as mine were disintegrated)
Sway bar bushings
REAR
Upper control arms
Lower control arms
Strut rod arms
Tie rod arms
Anything I'm leaving out?
Thanks!
Tons and tons of info about control arms, not going to go into that. Mine need replacing, and I just bought a new set of tires I don't want to wear out prematurely... tires are expensive So, what all should I replace while I'm in there?
I'm thinking:
FRONT
Upper control arms
Lower control arms
Tie rod ends
Steering rack bushings (recently did these, amazing difference as mine were disintegrated)
Sway bar bushings
REAR
Upper control arms
Lower control arms
Strut rod arms
Tie rod arms
Anything I'm leaving out?
Thanks!
#2
Lexus Champion
iTrader: (6)
Check out the Suspension and Brakes forum. This will get moved there.
I like to press in poly bushings on all control arms. Stabilizer bar bushings, end links, subframe bushings, diff bushings, motor mounts if its time for them.
I like to press in poly bushings on all control arms. Stabilizer bar bushings, end links, subframe bushings, diff bushings, motor mounts if its time for them.
Last edited by Studiogeek; 01-08-15 at 08:10 PM.
#5
Rookie
Thread Starter
@Studiogeek - that sounds like a solid plan. You use Daizen for everything or what?
@SC400slide - Rack mount bushing was replaced at the same time. Got the Daizen kit, $40 for each side and the rack bushing. It was so easy to take the old ones out because they were all non-existent lol
@Bankswood - Finding the control arms isn't the problem... finding the money for the control arms is. I wish someone would hurry up and release an aftermarket lower
@SC400slide - Rack mount bushing was replaced at the same time. Got the Daizen kit, $40 for each side and the rack bushing. It was so easy to take the old ones out because they were all non-existent lol
@Bankswood - Finding the control arms isn't the problem... finding the money for the control arms is. I wish someone would hurry up and release an aftermarket lower
#7
@Studiogeek - that sounds like a solid plan. You use Daizen for everything or what?
@SC400slide - Rack mount bushing was replaced at the same time. Got the Daizen kit, $40 for each side and the rack bushing. It was so easy to take the old ones out because they were all non-existent lol
@Bankswood - Finding the control arms isn't the problem... finding the money for the control arms is. I wish someone would hurry up and release an aftermarket lower
@SC400slide - Rack mount bushing was replaced at the same time. Got the Daizen kit, $40 for each side and the rack bushing. It was so easy to take the old ones out because they were all non-existent lol
@Bankswood - Finding the control arms isn't the problem... finding the money for the control arms is. I wish someone would hurry up and release an aftermarket lower
Thread
Thread Starter
Forum
Replies
Last Post
20GS300
LS - 4th Gen (2007-2017)
36
12-17-14 04:52 PM