Battle Version Tie rods
#16
I still need to bug Alex about the spacers he provided and how he used them
Last edited by RINTHAL; 08-10-12 at 11:25 AM.
#17
I was thinking about the joint side more because of the pin issue being high. Said something about bump steer but now that i go back and read it didnt make much a difference for Alex I may find my personal setting to be different requiring some test and tuning with different combos but i dont see this as a issue more curiosity. Pics not uploaded yet so I'm going back to wiring
#18
Here's a pic of the outer tie rod and how we run it.
You notice that it needs the 2 washers so that the cotter pin is at the right height for the nut.
The spacers for the lower section come in different heights, playing with the height will change bump steer but we suggest running it with the medium sized spacers both above and below the rod end.
The rod end is left hand thread so its easier to adjust then other brands.
You notice that it needs the 2 washers so that the cotter pin is at the right height for the nut.
The spacers for the lower section come in different heights, playing with the height will change bump steer but we suggest running it with the medium sized spacers both above and below the rod end.
The rod end is left hand thread so its easier to adjust then other brands.
#21
bump anybody used maverick steering angle spacer??
http://www.maverick-motorsports.com/...le-rackspacers
http://www.maverick-motorsports.com/...le-rackspacers
Thread
Thread Starter
Forum
Replies
Last Post