i've seen a TRD strut bar on a gs4 but never seen it on a gs3
My question is will it fit on a gs3?

I was planing on going all TRD and PLP under the hood

 

lol.. funny thing is i was just about to start a new thread to ask the same question

 

same mounting place in both cars so yes it should fit no problem...

 

Actually, I don't believe the TRD STB will fit on a GS3. The bar is round instead of flat. The engine sits higher and the bar won't clear without spacers. Even if you do spacers high enough to clear the engine (and you can pretty much forget the engine cover if you have one ), you will be hitting the hood.

 

does anyone on the board have a trd stb on a 3?

 

I think there are only a few that fit the GS3, like the UGO and the RMM. I dont think the TRD will fit, at least that is what I was told a year ago when I was looking for mine.

 

ok its confirmed... don't listen to me..lol.......sorry i meant well



hey rich your box is full i couldn't reply...

 

I just got the email that it was full. I cleaned it out.

 

nop it will not fit. even with the gs400 it will rub on the engine cover a bit if installed slightly off. it's going to hit on the gs3

for the gs3 you need something else, ugo for one

 

So just for clarification, can you put 1 on a GS430 with the engine cover?

 

i have a 98 gs3 with no engine cover.. will it fit? if not then wgere can i find the ugo one?

 

bro all we gotta do is test fit it...takes 10min tops (3 bolts each side) and I have an impact gun

 

sweet.. be back next week.. leavin for the road trip down to fl 2mrrw.

 

nop, for sure you can't do that, it will hit

 

the trd? i could be wrong, but from what i read i don't think so, not without some spacers