GA FS, Total Coilover swap, Eng Cover, Eibach Springs, Leather Armrest Covers

Thread Tools

Search this Thread

Jan 25, 2010 | 06:16 AM

ChampGS3

Thread Starter

Pit Crew

iTrader: (6)

Joined: Nov 2008

Posts: 107

Likes: 2

From: GA

FS, Total Coilover swap, Eng Cover, Eibach Springs, Leather Armrest Covers

I still have the Eibach Rear Springs for sale for a GS 300, 400 or 430, asking $60 OBO shipped.

Please email snyderd22@yahoo.com with any questions or you can send paypal to this same address if ready to purchase and I will Ship out ASAP!! Thanks.

Last edited by ChampGS3; Feb 18, 2010 at 01:15 PM.

Jan 27, 2010 | 05:53 AM

ChampGS3

Thread Starter

Pit Crew

iTrader: (6)

Joined: Nov 2008

Posts: 107

Likes: 2

From: GA

Eibach rear springs STILL AVAILABLE.

Last edited by ChampGS3; Jan 31, 2010 at 05:19 AM.

Jan 27, 2010 | 04:57 PM

GS4DOUGIE

Lead Lap

iTrader: (6)

Joined: Mar 2002

Posts: 744

Likes: 0

From: South OC

pm and emails sent-

Thanks in advance for the reply-

D

Jan 27, 2010 | 07:27 PM

4play4dr

Lexus Champion

Joined: Oct 2007

Posts: 2,750

Likes: 2

From: San Diego,CA

is it hard to install the new armrest covers?

Jan 27, 2010 | 11:25 PM

5t341th

Lexus Champion

iTrader: (16)

Joined: Aug 2008

Posts: 2,691

Likes: 12

From: SoCal (Huntington Beach)

hmm that grey armrest cover looks tempting. does it replace the old one or does it go over it?

Jan 28, 2010 | 08:33 AM

blacknmild

Pole Position

iTrader: (5)

Joined: Dec 2005

Posts: 329

Likes: 0

From: Florida

I have the same questions as 4play4dr and 5t341th

Jan 28, 2010 | 11:01 AM

ChampGS3

Thread Starter

Pit Crew

iTrader: (6)

Joined: Nov 2008

Posts: 107

Likes: 2

From: GA

Here is the deal, it takes a good hour, removing the top section, unscrewing the black plastic underside exposing the raw edges of the factory cover, then getting the new one into position for it to look absolutely perfect. You will most likely want to remove the old cover and then install the new one. I used contact cement, which sticks to leather great, to bond it to the plastic underside of the cover. For this visible item of your interior I would take all the time you need.

This cover was reverse engineered using a stock cover. The oem cover was carefully de-stitched and the 3 leather sections were cut exactly to match. So these leather covers have the exact same dimensions as the stock ones. They are then "doubled stitched" with matching thread for a OEM fit and finish. It doesn't get much better than that.

Anyway, I only have 2 armrest covers available, 1 grey and 1 camel/tan so let me know.