2jz-gte, 6-speed, sc300 complete
2jz-gte, 6-speed, sc300 complete
The car has been done for over a week, but I haven't had any time to post on hear so.. Its a 93 sc300 with 2jz-gte, the project took 41/2 months (lots of mods):2jz-gte(new short block,3angle valve job, extrude honed head,
bluprinted injectors) the car is full BPU(nothing else can be added to stock
twins, except cams) with an AEM EMS. It is running a RPS stage 3 sprung hub clutch with a Fidanza fly wheel. All of the work was done at Redlinemotorsports in Ft. Collins Colorado. www.4redlinemotorsports.com . The guys who worked on my car did very good work , they have tons of experence with Supras and did an almost factory looking install. The car is heavily modified, and with all of the mods I ended up paying less than most people pay for just the swap. I would suggest that anyone slightly interested in doing the swap give them a call @ 970-221-4805 and tell them that I sent you. Here are some pictures.
bluprinted injectors) the car is full BPU(nothing else can be added to stock
twins, except cams) with an AEM EMS. It is running a RPS stage 3 sprung hub clutch with a Fidanza fly wheel. All of the work was done at Redlinemotorsports in Ft. Collins Colorado. www.4redlinemotorsports.com . The guys who worked on my car did very good work , they have tons of experence with Supras and did an almost factory looking install. The car is heavily modified, and with all of the mods I ended up paying less than most people pay for just the swap. I would suggest that anyone slightly interested in doing the swap give them a call @ 970-221-4805 and tell them that I sent you. Here are some pictures.
Thread
Thread Starter
Forum
Replies
Last Post
xknowonex
SC - 1st Gen (1992-2000)
23
Aug 30, 2011 12:36 PM
xiaolong
SC - 1st Gen (1992-2000)
13
Aug 6, 2010 07:51 AM
