Check out my New Vent Gauge Pod / 52mm
#1
Driver School Candidate
Thread Starter
Check out my New Vent Gauge Pod / 52mm
Greetings CL,
I have been making quite a bit of things for the MK3 Supra community and I thought I would share my most recent development with the community here.
Specs:
------------------------
- Will Fit any 52mm Gauge
- Removable Cap on the Rear
- Made in the USA from ASA Plastic
- Impervious to Heat, Cold, UV Rays
- Plug n' Play without any modification needed
- Air Vents around the Gauge allow for Air to Flow
Thank you for your time.
I have been making quite a bit of things for the MK3 Supra community and I thought I would share my most recent development with the community here.
Specs:
------------------------
- Will Fit any 52mm Gauge
- Removable Cap on the Rear
- Made in the USA from ASA Plastic
- Impervious to Heat, Cold, UV Rays
- Plug n' Play without any modification needed
- Air Vents around the Gauge allow for Air to Flow
Thank you for your time.
#3
Lead Lap
iTrader: (8)
I was going to comment on all the vent mounts sacrificing air flow, then got to the last bullet point... Nicely done.
The uber fragile center vent is the big need for an aftermarket replacement, and also a good spot for a gauge or two. It looks like you have the capability of fabbing stuff from scratch, so that might be worth looking into.
The uber fragile center vent is the big need for an aftermarket replacement, and also a good spot for a gauge or two. It looks like you have the capability of fabbing stuff from scratch, so that might be worth looking into.
#4
Advanced
iTrader: (2)
I was going to comment on all the vent mounts sacrificing air flow, then got to the last bullet point... Nicely done.
The uber fragile center vent is the big need for an aftermarket replacement, and also a good spot for a gauge or two. It looks like you have the capability of fabbing stuff from scratch, so that might be worth looking into.
The uber fragile center vent is the big need for an aftermarket replacement, and also a good spot for a gauge or two. It looks like you have the capability of fabbing stuff from scratch, so that might be worth looking into.
Thread
Thread Starter
Forum
Replies
Last Post