Notices
SC - 1st Gen (1992-2000)

Starting up problem sc300

Thread Tools
 
Search this Thread
 
Old Aug 7, 2013 | 10:46 PM
  #1  
x2jzsc300x's Avatar
x2jzsc300x
Thread Starter
Driver School Candidate
 
Joined: Jul 2013
Posts: 44
Likes: 0
From: Ca
Default Starting up problem sc300

Hey cl got a issue with my car when I don't drive it for a couple hours it does a long crank then starts up and when I leave the car running for few mins and start it up again to see if it does it again and it doesn't it starts up fine the second time what's up with that? Any suggestion or help I have banged up the bottom pretty bad cuz I'm maxed on my tien coilovers but could that be a problem ? Help please
Reply
Old Aug 8, 2013 | 12:57 AM
  #2  
Boxxx's Avatar
Boxxx
Rookie
 
Joined: May 2013
Posts: 68
Likes: 1
From: AL
Default

Sounds like it's leaking fuel into the combustion chamber as it sits. Either leaking injector(s) or a faulty fuel pressure regulator. The next time you go to start it after it's been sitting for awhile, try starting it with the accelerator to the floor to see if it helps. If it does that's your problem.
Reply
Old Aug 8, 2013 | 01:09 AM
  #3  
Aron9000's Avatar
Aron9000
Lexus Champion
10 Year Member
Photogenic
Photoriffic
Shutterbug
 
Joined: Aug 2012
Posts: 4,592
Likes: 31
From: TN
Default

I know with my stock 2JZ it usually takes a couple seconds on cold starts. Hot starts you just blip the key and it fires right up.
Reply
Old Aug 8, 2013 | 05:01 AM
  #4  
BiGEZ's Avatar
BiGEZ
Instructor
iTrader: (24)
 
Joined: Oct 2009
Posts: 1,074
Likes: 143
From: Georgia
Default

Whats the condition of your battery? That could be it.
Reply
Old Aug 8, 2013 | 09:58 AM
  #5  
x2jzsc300x's Avatar
x2jzsc300x
Thread Starter
Driver School Candidate
 
Joined: Jul 2013
Posts: 44
Likes: 0
From: Ca
Default

Originally Posted by BiGEZ
Whats the condition of your battery? That could be it.
I really think it's the batterty, it's still the original battery then came with the car so imma replace that and hope that's the issue
Reply
Old Aug 8, 2013 | 10:12 AM
  #6  
SC4Paulo's Avatar
SC4Paulo
Lexus Test Driver
iTrader: (2)
 
Joined: May 2012
Posts: 1,242
Likes: 6
From: NV
Default

i have the same problem, i have been told my fuel pump wasnt getting enough voltage so i was told to do the 12volt mod. i still havent done it, mine doesnt occur as often as yours though, maybe once every 2-3 days. and white smoke comes out.

this is a different from what i just said.
this morning my battery did drain on me, when it started up it was taking a long time so i just gave it gas, then it started up.

Last edited by SC4Paulo; Aug 8, 2013 at 10:18 AM.
Reply
Old Aug 8, 2013 | 10:52 AM
  #7  
x2jzsc300x's Avatar
x2jzsc300x
Thread Starter
Driver School Candidate
 
Joined: Jul 2013
Posts: 44
Likes: 0
From: Ca
Default

Originally Posted by Kingshawty
i have the same problem, i have been told my fuel pump wasnt getting enough voltage so i was told to do the 12volt mod. i still havent done it, mine doesnt occur as often as yours though, maybe once every 2-3 days. and white smoke comes out.

this is a different from what i just said.
this morning my battery did drain on me, when it started up it was taking a long time so i just gave it gas, then it started up.
Yea no smoke coming out thank god but I think it's the battery cuz engine wise I replaced everything
Reply
Old Aug 8, 2013 | 11:40 AM
  #8  
x2jzsc300x's Avatar
x2jzsc300x
Thread Starter
Driver School Candidate
 
Joined: Jul 2013
Posts: 44
Likes: 0
From: Ca
Default

Ok update now my car is jerking now randomly abs goes and engine flashing it feels like it wants to die but by me pressing the gas it comes back
Reply
Old Aug 8, 2013 | 12:30 PM
  #9  
Boxxx's Avatar
Boxxx
Rookie
 
Joined: May 2013
Posts: 68
Likes: 1
From: AL
Default

You can test the battery and alternator with a multi-meter easily. With the car running place the negative probe onto the negative terminal and the positive probe onto the positive terminal. It should read around 14.4V with the car running. If it's in the 13's or lower you have a bad alternator, that or if you're lucky the belt is loose. With the car off and after it's sat for a minute or two the battery should read around 12.6V. If it's 12.2V or lower the battery is weak, but it may just need refilled with water and trickle charged before using it again.
Reply
Old Aug 8, 2013 | 01:30 PM
  #10  
Ali SC3's Avatar
Ali SC3
Lexus Champion
CL Folding 100,000
15 Year Member
Liked
Community Favorite
iTrader: (10)
 
Joined: Oct 2007
Posts: 10,806
Likes: 469
From: CO
Default

reset the ecu right before your next cold start. don't do it after turning it on, do a reset on a complete cold motor and let the ecu figure stuff out again when you start it after that.
Reply
Old Aug 8, 2013 | 01:54 PM
  #11  
x2jzsc300x's Avatar
x2jzsc300x
Thread Starter
Driver School Candidate
 
Joined: Jul 2013
Posts: 44
Likes: 0
From: Ca
Default

Originally Posted by Ali SC3
reset the ecu right before your next cold start. don't do it after turning it on, do a reset on a complete cold motor and let the ecu figure stuff out again when you start it after that.
Still kinda new to the whole car game how can I reset the ecu
Reply
Old Aug 8, 2013 | 02:19 PM
  #12  
x2jzsc300x's Avatar
x2jzsc300x
Thread Starter
Driver School Candidate
 
Joined: Jul 2013
Posts: 44
Likes: 0
From: Ca
Default

Since I'm slammed could I have done any damage underneath that could cause my problems ?
Reply
Old Aug 8, 2013 | 03:14 PM
  #13  
Boxxx's Avatar
Boxxx
Rookie
 
Joined: May 2013
Posts: 68
Likes: 1
From: AL
Default

Can reset the ECU by leaving the battery disconnected or pulling the ECU fuse for a few minutes. Part of the wiring harness runs through the fender.
Reply
Old Aug 9, 2013 | 06:48 AM
  #14  
nlc's Avatar
nlc
Pole Position
 
Joined: Feb 2011
Posts: 238
Likes: 0
From: S.FL
Default

did you tuck that wire harness under your fender since ur slammed as you say? when my dash lights did wat you described and my car behaved that way my battery was telling me something.. GL
Reply
Old Aug 9, 2013 | 07:20 AM
  #15  
Ali SC3's Avatar
Ali SC3
Lexus Champion
CL Folding 100,000
15 Year Member
Liked
Community Favorite
iTrader: (10)
 
Joined: Oct 2007
Posts: 10,806
Likes: 469
From: CO
Default

yeah you could have started to rub through that harness by now.
Reply



All times are GMT -7. The time now is 01:32 PM.