Notices
SC - 1st Gen (1992-2000)

trac light problem

Thread Tools
 
Search this Thread
 
Old Dec 14, 2012 | 12:56 PM
  #1  
Markysc4's Avatar
Markysc4
Thread Starter
Driver School Candidate
 
Joined: May 2012
Posts: 24
Likes: 0
From: Ny
Default trac light problem

Whats up my fellow sc owners I just ran into a little problem ...I started to drive my sc which is a 400 and my trac light came on I pulled over shut her off and started back up trac light went off haven't came back on yet but can someone please tell me what is the problem...thank you
Reply
Old Dec 14, 2012 | 12:57 PM
  #2  
SC400slide's Avatar
SC400slide
In Recovery Mode
CL Folding 25,000
iTrader: (11)
 
Joined: Apr 2012
Posts: 3,871
Likes: 36
From: NM
Default

You hit a pothole.
Reply
Old Dec 14, 2012 | 01:03 PM
  #3  
Markysc4's Avatar
Markysc4
Thread Starter
Driver School Candidate
 
Joined: May 2012
Posts: 24
Likes: 0
From: Ny
Default

Lol really ? Usually it'd start blinking not stay on

Last edited by Markysc4; Dec 14, 2012 at 01:08 PM.
Reply
Old Dec 14, 2012 | 01:34 PM
  #4  
SC400slide's Avatar
SC400slide
In Recovery Mode
CL Folding 25,000
iTrader: (11)
 
Joined: Apr 2012
Posts: 3,871
Likes: 36
From: NM
Default

I was sorta being sarcastic, Lexus CEL go on if you drop a tennis ball too close to it. I wouldn't worry about it if the light didn't stay illuminated.
Reply
Old Dec 14, 2012 | 02:01 PM
  #5  
Kalogerus's Avatar
Kalogerus
Lexus Test Driver
iTrader: (3)
 
Joined: Oct 2011
Posts: 1,064
Likes: 1
From: VA
Default

There is an accumulator next to the master cylinder on the driver side under the hood, get a plastic line and attach it to the nipple and the other end into a bucket and loosen the nipple to remove any air from there. Also attached to that accumulator is a high pressure line, check if it is cracked/hard/bulged/damaged.

I have been trying to locate this hose by itself but it comes with the accumulator as a set. Got a used one for 50 shipped off of ebay.

PS. If you're going to replace, before you take anything else apart, save yourself a lot of hassle and see if you have the tools to remove the hose first. The transmission dipstick wont allow anything over an inch in width in between and u need a lot of torque to loosen that sucker.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
CheVelleSS
SC - 1st Gen (1992-2000)
7
Dec 14, 2013 03:30 PM
simrx3
LS - 1st and 2nd Gen (1990-2000)
2
Nov 12, 2013 06:01 PM
johnnybmw1
SC - 1st Gen (1992-2000)
6
Jun 11, 2009 11:40 PM
mac187
GS - 1st Gen (1993-1997)
7
Sep 9, 2008 04:26 AM
mjr24
SC - 1st Gen (1992-2000)
21
Nov 24, 2002 06:12 AM




All times are GMT -7. The time now is 08:40 AM.