it's been awhile since i last took off my flywheel but i just recieved my lightweight flywheel today and the hole in the center is a lot bigger than the pilot bearing. is that normal, i always thought the pilot bearing was supposed to be a snug fit in the center hole? i need to know if it's right or wrong so i can send it back.

 

pilot doesn't sit in the flywheel, it's supposed to sit in the crankshaft you'll see it when you get your trans pulled.

 

Thanks, I kind of had a feeling it was supposed to go there.

 

btw do anyone remember how many quarts does the w58 takes?

 

Its like 2-3/4. Just pull the fill plug, and pour it in the shifter hole until starts to run out of the fill plug hole.

 

thanks. i did it a few times before but it's been 2+ years ago and i just forgot how much quarts it uses.