Motor swap "Sorda"
Motor swap "Sorda"
Hey guys, I started out doing a vvti swap into my sc300. But then decided i wanted to run a standalone and would be easier just to use my NA head on my GTE bottom end. That way everything will connect right up with light mods. I have a few questions im trying to figure out, Has anyone used the ebay intake manifold with velocity stacks ect? Also what MM is the factory GE throttle body? Would i be better off swapping to a GTE Throttle body or aftermarket? If so does anyone have any reference? I know it really doesnt matter on this question but are the factory GE injectors high or low impedance injectors? Ive done some research on all of this and havent had to much of luck.. i was thinking about going 1000cc ID injectors, I know i can use the factory top feed fuel rail but is there a good aftermarket alternative? trust me ive looked lol. Any help would be very appreciated Thanks in advance!
Thread
Thread Starter
Forum
Replies
Last Post
JDMSoarer5
SC - 1st Gen (1992-2000)
7
Aug 23, 2012 09:30 AM
