SC angle mods!
If it helps your decision at all, When I hit the wall my lower control arm buckled and cracked while my knuckles that Alex did for me are PERFECT still. if that doesn't break them nothing will.
If you weld cast which is kind of a no no it is a ticking time bomb so to speak as casting is a dirty proscess so a weld can not properly stick but it may be ok for a while or forever even as long as there is not a whole lot of strain on it however I my self would never trust my life to that at high speeds,
some people may shorten that to PSM
The website is www.poweredbymax.net and some shorten that to PBM
We just call it MAX for short.
The knuckle service is called ka-ko (Kako is Japanese for modified)
there is a thread on that here
Last edited by BigWaveSC; Jan 11, 2012 at 11:58 AM.
They just posted this; http://www.gtfactory.jp/cms/e107_plu...topic.php?5925
$250 ain't a bad price...
$250 ain't a bad price...
Last edited by OG Dada; Jan 11, 2012 at 02:47 PM.
I wish I could find the knuckles that Fredric Aasbo used on his Supra. At one time I think I found them on Japan Auto's site but i didnt understand the site very well so I wasnt sure. Now I dont see them on there, http://japanauto.no/
Im sure if we could get them they would cost an arm and a leg, but that car was just crazy.
Im sure if we could get them they would cost an arm and a leg, but that car was just crazy.
Driver School Candidate
Joined: Nov 2011
Posts: 34
Likes: 0
From: CO
Bigwave- How many degrees of angle do you have?
Did my first event in the car yesterday.... knuckles are a must for how aggresively I like to throw the car in/transition. I had to baby it in comparison to my Z33 and I hate that.
Did my first event in the car yesterday.... knuckles are a must for how aggresively I like to throw the car in/transition. I had to baby it in comparison to my Z33 and I hate that.
Driver School Candidate
Joined: Nov 2011
Posts: 34
Likes: 0
From: CO
http://www.gtfactory.jp/cms/e107_plu...5.10#post_9528
This just posted on the PBM forums. I'm pretty excited to get knuckles. Just curious how low of an offset wheel I'll need to use in order to utilize the max amount of angle or at least close to it.
This just posted on the PBM forums. I'm pretty excited to get knuckles. Just curious how low of an offset wheel I'll need to use in order to utilize the max amount of angle or at least close to it.
