spotted some rust now, after fenders rolled
#1
spotted some rust now, after fenders rolled
I spotted some rust on my front fenders in areas where the paint chipped when I rolled the fenders. I neglected to seal up the cracks and chips.
I know rust gets worse and spreads, it may get under the paint and keep going.
What can I do to stop the rust and seal it before it gets worse? I wasnt able to check the rear fenders, but will tomorrow.
The rears would be a hassle if it spreads. I would need a new paint job, since its not one seperate panel. The fronts if it spreads I can just get the fenders repainted.
I was planning on painting my whole car, but that changed, so I need to fix this asap.
I know rust gets worse and spreads, it may get under the paint and keep going.
What can I do to stop the rust and seal it before it gets worse? I wasnt able to check the rear fenders, but will tomorrow.
The rears would be a hassle if it spreads. I would need a new paint job, since its not one seperate panel. The fronts if it spreads I can just get the fenders repainted.
I was planning on painting my whole car, but that changed, so I need to fix this asap.
Last edited by soulific; 12-14-09 at 02:38 AM.
#4
Lead Lap
iTrader: (6)
I've used this stuff before on my Jeep. http://www.por15.com/POR-15/productinfo/1GB/ worked wonders. But I would suggest doing it the right way like they said.
Thread
Thread Starter
Forum
Replies
Last Post
rukkus2IS
IS - 2nd Gen (2006-2013)
17
07-29-10 08:38 PM