Last edit by: IB Advertising
See related guides and technical advice from our community experts:
Browse all: Steering and Suspension
Browse all: Tires and Wheels Guide
- IS ES GS: Lowering Modifications
Important information to help you understand your Lexus
- How to Mount a Tire to your Rim
Step by step instructions for do-it-yourself repairs
- Tires General Information and Specs
Important information to help you understand your Lexus
Browse all: Steering and Suspension
Browse all: Tires and Wheels Guide
****Official Wheel & Tire Fitment Guide for SC300/SC400****
#1953
#1954
Hacked CL to become a Mod
even with stretch i think you would need to roll the rears for a problem free driving...or you can always let it ride high and go slowly over bumps
#1955
Pole Position
Join Date: Dec 2007
Location: Wellington New Zealand
Posts: 235
Likes: 0
Received 2 Likes
on
2 Posts
You can't have low, flush and stock fenders, it just isn't possible.
Those wheel specs will be close to flush which will cause you problems even with stretched tires.
Just get the fenders done as you will end up wanting to go lower and wider soon.
Matt.
Those wheel specs will be close to flush which will cause you problems even with stretched tires.
Just get the fenders done as you will end up wanting to go lower and wider soon.
Matt.
#1956
Lead Lap
iTrader: (1)
Join Date: Jul 2008
Location: nc
Posts: 766
Likes: 0
Received 0 Likes
on
0 Posts
their is no way i can check all of these to see if someone have this set up if you do guide me to the pic.but here goes rim size 20x8.5 all around offset 38 tires 255/35/20 how will this look and i allready have the rims but not the tires.thanks for your help fellas
#1957
Hacked CL to become a Mod
^ lowered to one finger gap, I'd say you will be sunken by a thumb. I have the same offset in the back, but wider rims, 10'. You will most likely have to modify/remove the front fender liner. Fronts will be sunken by around 2 cm
#1964
Driver School Candidate
Join Date: Jan 2008
Location: Texas
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
Looking for alot of advise. My goal is to make no fender mods with no rubbing but the offsets for the wheels I want are limited. Also suggestions for tires? Will this work and look OK?
18x9 front offset +30
18x10 rear offset +40
18x9 front offset +30
18x10 rear offset +40
#1965
Hacked CL to become a Mod
you will need a slight roll in the back if you do decide to lower it