Pulling the engine code???
Driver
Joined: Jun 2006
Posts: 173
Likes: 0
From: Ca
you have to use a little bit of wire. and jump the 2 connectors in the DIAGNOSE(spelling) i believe it's T1 and E1. The connector is located on the intake side of the 1j. Not 100% sure if it's in the same location as a 2j or 1u.
Thread Starter
Driver
Joined: Jul 2004
Posts: 93
Likes: 1
From: Illinois
Do u know where in the engine these are located?
theres another trick u can do.. i dont know if its as usefull as doing that way stated up ^^..
but i guess u can try it.. i believe u press and hold AC and recirculate and then turn on the car (not engine)
then it does stuff.. iono wat it means but.
mine says
11 (Beep)
21 (Beep)
23 (Beep)
41 (no beeP)
but i guess u can try it.. i believe u press and hold AC and recirculate and then turn on the car (not engine)
then it does stuff.. iono wat it means but.
mine says
11 (Beep)
21 (Beep)
23 (Beep)
41 (no beeP)
Zombie Slayer
Joined: May 2004
Posts: 6,053
Likes: 3
From: East Bumble F, NJ
Not in the engine. In the diagnostic port under the dash, drivers side.
Try here:
http://www.troublecodes.net/Lexus/
Try here:
http://www.troublecodes.net/Lexus/
Thread
Thread Starter
Forum
Replies
Last Post
