Question about swapping Interior Parts
03-28-06, 01:52 PM
#16
Rookie
Thread Starter
Join Date: Aug 2005
Location: NJ
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
yes...i've seen their cars interior pictures and i can only aspire for mine to look as great as those.
but back to my previous question where do u think i can get replacement nuts, bolts, and screws for the interior? dealer, or do u think i can find similar products over a a local home depot type place.
but back to my previous question where do u think i can get replacement nuts, bolts, and screws for the interior? dealer, or do u think i can find similar products over a a local home depot type place.
03-31-06, 05:11 AM
#18
Pole Position
Originally Posted by marek0rn
bump...no one has an answer for me? 
A lot of the hardware is specialized like clips, retainers, etc. The nuts, bolts and screws are somewhat normal although obviously metric.
At the dealer they can get expensive if you need a LOT of the hardware.
Why do you feel the need to change all your hardware? Are they rusted or ugly? Can't be for looks as every last nut, bolt and screw is hidden from view.
If you are just missing a few, try the dealer or hit up a u-pick junkyard. Raid any Toyota for the stuff, it's mostly all the same crap. Remember, at the u-picks, if it fits in your toolbox or pocket, it's free. 
I have a tin chock FULL of '90 Celica hardware from my complete blue --> grey interior swap and just about everything in it fits fine on my SC.
03-31-06, 12:52 PM
#19
Driver
Join Date: Oct 2005
Location: Ohio
Posts: 116
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by sc.Fred
this is a little bit off topic, but has anybody swapped out a entire tan interior for a black one? i would like to know how much it would run if i was lucky enough to find an interior and how much time would it take to install everything, i know it's going to be an adventure and a half!
Thread
Thread Starter
Forum
Replies
Last Post
Jeremiah87
LS - 1st and 2nd Gen (1990-2000)
28
10-09-13 08:04 AM
