does anyone make one for the sc300/400? looks like this http://www.mkiv.com/techarticles/dol...ace/index.html

 

As far as I know, Do-Luck is the only manufacturer producing such a bar. Oddly, they produce one for the Supra, but the SC isn't listed. Looking at the photos I would assume that the Supra one would fit, as long as it clears the transmission hump, and tucks under the bars that anchor the seat belts. I guess we won't know until someone tries it, and I've contemplated being the test subject.

 

i wouldn't mind having this also. There is some adjustablity so i think it may fit.... anyone brave enough to try?

 

PM TurboB6....He had something like that awhile back. He has had a few DoLuck products, so he may know about the fitment.







gadgetSC-t

 

good idea i bought the do-luck brace and YSR support bars from him. maybe he can reply here so we can all find out!

turboB6!!! where are you!!!

 

yea i wanna get one since the supra people says it helps more than a front and rear strut bar combined.

 

talking about strut bars... does the supra rear strut brace fit the SC400's?

 

Are we talking front or rear? The only front one I know of is the JIC piece. I have one and it just barely clears the intake manifold of the earlier 1UZFE. Actually, it doesn't even clear until you remove the Lexus emblem off the top of the manifold. I suppose you could create a spacer or use washers to lift it slightly. I don't believe that anyone produces a rear strut bar for the SC. I custom built one from a cheap Supra front bar.

 

Do you think you could take some pics of your rear bar? Id love to use the supra rear bar i have sitting in my garage, but the designers decided to put a gastank there.

 

I actually just took the rear out this past weekend to redo the end brackets. I'm planning on installing Tein coilovers w/ EDFC. My original design didn't leave enough room for the EDFC motors. I'll take a picture as soon as it's finished. The basic design runs a straight oval bar over the gas tank with long curved end brackets, essentially creating a rear arch over the tank.

 

:subscribed:

 

i would love to see the rear bar also... I am aware of the JIC front STB fitting with the emblem removed or with spacers...

 

Do you have any pics of the custom rear bar you made installed on the car?

 

How much does that rear floor brace cost? I may be brave (stupid) enough to try it if it isnt too expensive.

 

Floor Support Bar Aluminum $520.00
Floor Support Bar Steel $400.00
website is www.do-luck-usa.com