Notices
RX - 3rd Gen (2010-2015) Discussion topics related to the 2010 - 2015 RX350 and RX450H models

Replace cabin and now A/C doesn't work

Thread Tools
 
Search this Thread
 
Old Feb 13, 2014 | 05:23 PM
  #1  
Kenji07250's Avatar
Kenji07250
Thread Starter
Driver
 
Joined: Feb 2010
Posts: 100
Likes: 0
From: SoCal 213
Unhappy Replace cabin and now A/C doesn't work

Hey CL,

I just recently replaced the cabin filter on my 2012 rx350 and now the A/C doesn't work. I checked under the hood and the compressor doesn't kick in. Any ideas what caused it? Or should I take it to the dealership to have it checked out? It only has about 20,000 miles too
Reply
Old Feb 13, 2014 | 05:35 PM
  #2  
corradoMR2's Avatar
corradoMR2
The pursuit of F
15 Year Member
Photogenic
Liked
Loved
 
Joined: Jul 2006
Posts: 8,296
Likes: 303
From: Toronto, Canada
Default

hmmm, that must be a complete coincidence or the AC wasn't working prior to the cabin filter.

Sure, let the dealer know, but if this was my car to attempt to avoid a trip, I'd first try to "reboot" the car by unplugging the positive terminal from the battery, wait a few seconds, re-plug it back in. Then test. Good luck.
Reply
Old Feb 13, 2014 | 06:33 PM
  #3  
Kenji07250's Avatar
Kenji07250
Thread Starter
Driver
 
Joined: Feb 2010
Posts: 100
Likes: 0
From: SoCal 213
Default

I unplugged the terminal and rebooted it. Still doesn't work. I guess dealership I go then
Reply
Old Feb 13, 2014 | 06:46 PM
  #4  
corradoMR2's Avatar
corradoMR2
The pursuit of F
15 Year Member
Photogenic
Liked
Loved
 
Joined: Jul 2006
Posts: 8,296
Likes: 303
From: Toronto, Canada
Default

^^^ Was worth a try. Very unusual and rare. It's too bad, but at least it will be under warranty. Good luck and keep us posted.
Reply
Old Feb 13, 2014 | 06:58 PM
  #5  
pheonix72's Avatar
pheonix72
Lead Lap
iTrader: (6)
 
Joined: Dec 2013
Posts: 654
Likes: 7
From: ca
Default

Did you follow the procedure and put the AC in RECIRCULATE mode first? You might have broken something? I would advice that you put the old filter back in before bring it in so the dealer wont give you a hard time.
Reply
Old Feb 13, 2014 | 07:13 PM
  #6  
Kenji07250's Avatar
Kenji07250
Thread Starter
Driver
 
Joined: Feb 2010
Posts: 100
Likes: 0
From: SoCal 213
Default

I don't remember if I did. I checked the inside to see if I did break anything. When I pushed the recirc the flap moved. I hope I didn't break anything. :x
Reply
Old Feb 14, 2014 | 03:01 AM
  #7  
ggebhardt's Avatar
ggebhardt
Pole Position
 
Joined: Jan 2005
Posts: 3,312
Likes: 542
From: Florida
Default

From what I remember it is very important that the instructions be followed or something DOES break.

I hope this is not the case
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Stereorob
LS - 1st and 2nd Gen (1990-2000)
13
Feb 23, 2019 06:03 AM
EskieFan54
LS - 4th Gen (2007-2017)
3
Sep 29, 2012 10:15 AM
IStoSC
LS - 4th Gen (2007-2017)
16
Nov 8, 2010 09:56 AM
TEXAS83
SC430 - 2nd Gen (2001-2010)
1
Jun 11, 2007 03:43 PM
2k1GS3
Maintenance
20
Jan 29, 2003 05:33 PM




All times are GMT -7. The time now is 12:26 PM.