Changing Fog Light Bulbs???? HELP
Thread Starter
Driver School Candidate
Joined: Dec 2010
Posts: 14
Likes: 1
From: Pa
Changing Fog Light Bulbs???? HELP
Hi - I am a new (used) Rx 350 owner and need to change the fog light bulbs. The owners manual says to access through the 2 holes directly beneath the fog lights but there is too much stuff in the way and i cannot get my hand in.
Ant thoughts are appreciated. Do i have to access by removing the fender liner??
Thanks
2009 RX 350
Ant thoughts are appreciated. Do i have to access by removing the fender liner??
Thanks
2009 RX 350
The passenger side fog light should be easily accessible through the hole. You just have to fiddle around in there until you can feel the connector. The driver side is not as easy though, you need to open up the fender liner a little bit in order to gain access to it.
I did not have to go through the wheel well for the driver's side. It was also accessible through the front, as was the passengers side. Maybe ask your wife/gf to do it since they have "thin" hands/arms 
Driver
Joined: Mar 2008
Posts: 107
Likes: 2
From: PA
For the passenger side, I had to remove the washer fluid hose and I was able to reach down to change the bulb.
For the driver side, I had to loosen the battery hold-down bracket, move the battery an inch or so, and I was then able to reach down and replace the bulb.
For the driver side, I had to loosen the battery hold-down bracket, move the battery an inch or so, and I was then able to reach down and replace the bulb.
Thread
Thread Starter
Forum
Replies
Last Post
ReyRey305
GS - 3rd Gen (2006-2011)
7
Apr 8, 2008 05:38 AM
