2004 RX330 catalytic code issue
It now has 250,059 miles and has been maintained to the highest degree with no winter salt exposure, original running gear, exhaust and suspension. One master mechanic, pulled the P0430 code and did a pressure check (ok) and replaced one sensor and suggested we use a fuel cleaner additive, which we did and a week later, same lights/code popped up and keep appearing intermittently ever since At 132,248 miles, replaced spark plugs (Iridium) and intake plenum gasket. At 150,554 replaced valve cover gaskets. At 179,513 replaced timing belt, water pump, coolant. At 204,094 replaced spark plugs (Iridium), upper intake gasket set, both throttle body gaskets, cleaned fuel injectors. At 208,300 replaced bank 2 catalyst with a Walker brand, same issue. Replaced all four cat sensors with Denso units...no help. At 233308 miles, replaced intake manifold gasket, thermostat, cross pipe water hose, coolant. At 249215 replaced air flow meter, no help. Denso products were used wherever possible. Intake air filters replaced as required. We use Top Tier fuel and drive normally with occasional light towing.
I'm a retired outboard motor mechanic and am astute about keeping our vehicles in top condition, but this cat warning system has not only me stumped, but also five more certified repair shops as well. My only thought is that we have a bad electrical ground somewhere. The car won't pass CA smog tests, so can't get it licensed in CA. MN does not have smog tests, so it remains registered there (our legal residence). Any ideas? Thanks









