How do 4.5" x 5" tips look on a GS400?
Pretty good if you ask me. And whoops, they are 4"x5".





Polished Stainless Oval Rolled Angle Exhaust Tip 2 1/4" IN 4" X 5" Out
http://www.ebay.com/itm/260907405774...S:3160&vxp=mtr





Polished Stainless Oval Rolled Angle Exhaust Tip 2 1/4" IN 4" X 5" Out
http://www.ebay.com/itm/260907405774...S:3160&vxp=mtr
Last edited by RoMiLex; May 7, 2014 at 03:15 PM.
Sorry no video. Its got a nice sound with alot of low end rumble. Volume isnt bad at all. Cruising on the highway its barely louder than stock. Light to light and under 2k rpm is where is most noticeable.
Ah, so it should sound much like mine then, with a bit of drone under 2k RPM... if you need a sound clip, I have posted my GS when on the dyno just a few threads below. I imagine the intake should sound about the same so no difference there between our 2 cars.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Flogrown
2Gen IS250 / IS350 / IS-F Classifieds (06-13)
7
Jan 13, 2016 04:27 PM
FabX
LS - 1st and 2nd Gen (1990-2000)
5
Aug 18, 2008 08:43 PM








