Manual Conversion
Thread Starter
Driver School Candidate
Joined: Aug 2008
Posts: 9
Likes: 0
From: Alabama
Manual Conversion
I own a 2003 IS300 with the automatic transmission with the triptonic shifter, and I was wondering how hard it would be to do a manual conversion. I don't want to do a 2jzgte/v161 swap, as I don't have that much money. I would like to keep the 2jzge engine in. Would a 2002 IS300 5 speed transmission work with the car?
Rookie
Joined: Jul 2008
Posts: 78
Likes: 0
From: Ft. Knox KY
of course it would, but its alot more than just the tranny that you need,
for starters you'll need at least the following.
tranny
peddle set
shifter ***.
clutch master and slave cyl. and res.
clutch lines.
manual tranny computer
and i dont even know about the drive shaft and rear end.
do a couple of searchs on my.is i think ive either seen someone selling the stuff needed or a how to or some thing.
for starters you'll need at least the following.
tranny
peddle set
shifter ***.
clutch master and slave cyl. and res.
clutch lines.
manual tranny computer
and i dont even know about the drive shaft and rear end.
do a couple of searchs on my.is i think ive either seen someone selling the stuff needed or a how to or some thing.
Thread
Thread Starter
Forum
Replies
Last Post
