help! CEL, VSC, VSC OFF lights on! no acceleration...

Subscribe
Jan 26, 2007 | 03:01 PM
  #1  
help guys!

something is wrong with my car... my CEL, VSC, and VSC OFF lights all turned on, and my gas pedal doesnt work unless i press it *all the way down.* am i in limp mode? i unplugged the 2 sensors next to the throttle body to try and get rid of the lights but it didnt work. then i disconnected the battery for 15 minutes to reset the ECU and that didnt work either.

i've been searching on CL and i think i need either a TPS or an accelerator position sensor. which one do i need and how much do each of these cost?

and can i buy these from carson or sewell (contact info?)?

thanks in advance guys
vince
Reply 0
Jan 26, 2007 | 04:50 PM
  #2  
you need to plug in the obd 2 scanner and see what codes you are throwing. Usually the vsc lights are associated with suspension components. Go to autozone and they can pull the code for you for free.
Reply 0
Jan 26, 2007 | 05:21 PM
  #3  
yeah go to Autozone and pull the code. the scanner will give u a little info about the code. keep us posted...
Reply 0
Jan 26, 2007 | 06:04 PM
  #4  
It also could be your (TPS) Throtle Position Sensor
Reply 0
Jan 26, 2007 | 06:52 PM
  #5  
Pull the codes.

I had the same prob.
Codes I got was P1120 and P1121

Looked up the the codes and it was the Accelerator Pedal Position Sensor

Bought the part 2206046010-LEVER ASSY, THROTTLE from Lexus
Installed it the same night it arrived.

No more problemo!
Reply 0
Jan 26, 2007 | 06:55 PM
  #6  
BTW: The information I found on this site was priceless. I am a new Lexus owner and it turns out the this is a common problem with the GS.
Reply 0
Jan 26, 2007 | 07:04 PM
  #7  
Had a similar problem today. Restarted the car and the problem went away. The night before I got a car wash and it was realy cold afterwards -17, I'm hoping that was part of the problem. Never happened before and I hope never again.
Reply 0
Jan 26, 2007 | 08:48 PM
  #8  
Quote: Pull the codes.

I had the same prob.
Codes I got was P1120 and P1121

Looked up the the codes and it was the Accelerator Pedal Position Sensor

Bought the part 2206046010-LEVER ASSY, THROTTLE from Lexus
Installed it the same night it arrived.

No more problemo!
thanks for the input guys,

ok i went to autozone and i got one code: P1120. so i guess i'm in the same boat as blackgs415. how much does this Accelerator Pedal Position Sensor cost?

and BTW this also happend to me after i got my car washed! it wasnt that cold either, approximately 25 degrees out yesterday and 40 degrees today...
Reply 0
Jan 26, 2007 | 09:00 PM
  #9  
BTW whats what's carson lexus's contact info and who do i talk to there?
Reply 0
Jan 27, 2007 | 02:27 AM
  #10  
Found the part for $221 at Park place Lexus, Check Carason Toyota 1-800-908-6968 or 310-522-2300 and Try Sewell Lexus

http://www.trademotion.com/partlocat...&siteid=213808

Before I buy anything I would try re-setting the ECU who knows it may fix the problem?
Reply 0
Jan 27, 2007 | 05:45 AM
  #11  
Quote: It also could be your (TPS) Throtle Position Sensor
I saw TPS & had a mental picture of Office Space. LOL
Reply 0
Jan 27, 2007 | 08:32 AM
  #12  
Quote: Pull the codes.

I had the same prob.
Codes I got was P1120 and P1121

Looked up the the codes and it was the Accelerator Pedal Position Sensor

Bought the part 2206046010-LEVER ASSY, THROTTLE from Lexus
Installed it the same night it arrived.

No more problemo!

Is it an easy DIY?
Reply 0
Jan 27, 2007 | 09:20 AM
  #13  
i also got the same lights on(CEL, VSC , VSC OFF) and the code i got is P0505( Idle control system malfunction). what parts do i need to replace? the thing is my car runs just fine.
Reply 0
Jan 27, 2007 | 04:11 PM
  #14  
Quote: Found the part for $221 at Park place Lexus, Check Carason Toyota 1-800-908-6968 or 310-522-2300 and Try Sewell Lexus

http://www.trademotion.com/partlocat...&siteid=213808

Before I buy anything I would try re-seting the ECU who knows it may fix the problem?


thanks for going the extra mile for me! i said earlier though that i already tried resetting the ECU and it didnt work.


BTW so i started my car this morning and strangely enough all the check lights didnt show up this time and my car ran perfectly fine. i dont know whats up with my car, but i thinking i should get that part anyway to ensure that this doesnt happen again...
Reply 0
Jan 27, 2007 | 07:49 PM
  #15  
spoke too soon @#%@$
i guess i spoke too soon guys. so i was on my way out tonight and i turn on my car and bamm, on come all the CEL lights again...


arrgh
Reply 0