When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I have TRAC light on and O/D OFF blinking light. Decided to find out fault codes according described procedure. But the problem is that my "check engine" light is not appearing as it should. It does not appear even when ignition is on and i am starting engine.
The bulb is ok i am sure, because before i changed capacitors for my ECU "check engine" light was on. Does anybody had such issues??
Finally i changed my ECU. Bought one refurbished with warranty from ebay. Check engine light operates now as it should and i can read out trouble codes of engine now normally. I have now code 28, but most likely not because O2 sensor, but of poor grounding somewhere... Could someone tell me or show where these grounding points exactly are?
Last edited by andiniku; 02-22-18 at 06:41 AM.
Reason: want to add foto
01-04-18, 11:52 PM
92 SC400 check engine light dissapeared
