Acuna928

Just finished putting a Water Pump and timing belt on my recently bought SC. And afterwards I noticed my temp gauge slowly rising over the operating range and check all hoses and radiator but it all checked out. Except that my Fan wasn't spinning at all. And that a wire of the Hydrualic Fan Soleniod was cut off from the entrance of where the wire goes into the solenoid. And was wondering if that could be the whole cause of it. If not any troubleshooting methods or things to look for to make sure the Fan isn't completely done for. Thank you.

Returd

Did you resolve this?

Acuna928

No I haven't. I've been looking for a shop.