Help with Sheila
#1
Driver
Thread Starter
Help with Sheila
Well I finally found a car worth busting my knuckles
But she needs a lot of work.
Before the Peanut Gallery ask did I use the search button Yes it takes too much time and I need it to work on her
anyhow thought I share as I embark on long project with the red head
This car at some point on Ohio and ended up here in SAT
I got it for a good price she ran a little rough but I think I got most of the issue worked out.
First step was to clean her up little bit will post working on getting rid of the salt issues. and preventing rust. cowl is fine and only the trunk had a small spot
any way advice on intakes and exhaust been looking for sound clips on you tube but not much.
so please post links
Thank you.
But she needs a lot of work.
Before the Peanut Gallery ask did I use the search button Yes it takes too much time and I need it to work on her
anyhow thought I share as I embark on long project with the red head
This car at some point on Ohio and ended up here in SAT
I got it for a good price she ran a little rough but I think I got most of the issue worked out.
First step was to clean her up little bit will post working on getting rid of the salt issues. and preventing rust. cowl is fine and only the trunk had a small spot
any way advice on intakes and exhaust been looking for sound clips on you tube but not much.
so please post links
Thank you.
#5
Driver
Thread Starter
I am not feeling the wheels and I have not got to clean them yet, they are American Racing chrome with dirt from neglect
LMAO
I will most likely get rid off them, I am using them as roller not bad wheels just not my taste.
LMAO
I will most likely get rid off them, I am using them as roller not bad wheels just not my taste.
#6
Driver
Thread Starter
well by now I need find best place and price for an INJEN Intake. ( or other brand available... I guess they are still hovering above the $200 mark if anyone knows of a deal please pm.
I am getting tired of removing and repairing during reinstall the factory assy.
will be needing coil over here in the near future considering Godspeed mono RS this wont be a track car (yet)
also a complete install proly will go with freeflow cats, x pipe and some shiny cat back the whole exhaust is junk
boy some links to video sound would be nice
I am getting tired of removing and repairing during reinstall the factory assy.
will be needing coil over here in the near future considering Godspeed mono RS this wont be a track car (yet)
also a complete install proly will go with freeflow cats, x pipe and some shiny cat back the whole exhaust is junk
boy some links to video sound would be nice
Thread
Thread Starter
Forum
Replies
Last Post
Gville350
IS - 2nd Gen (2006-2013)
7
08-18-13 08:34 AM
magnetik
Lexus Audio, Video, Security & Electronics
18
01-31-08 03:38 PM