Starter Changing Woes
04-01-13, 05:44 PM
#1
Lexus Test Driver
Thread Starter
Join Date: Mar 2006
Location: Lake Ray Hubbard
Posts: 845
Likes: 0
Received 0 Likes
on
0 Posts
Starter Changing Woes
Ready to set my SC on fire and dall it a day. How do I remove the rear wire loom & that plastic casing that is keeping me from being able to get to the 2 rear bolts to remove the rear water bypass joint, which is impeding me from being able to reach the starer bolts?? TIA
I've been following this diagram http://lextreme.com/starter.html but I am at an impass.
I've been following this diagram http://lextreme.com/starter.html but I am at an impass.
04-03-13, 05:31 AM
#2
Lexus Test Driver
Thread Starter
Join Date: Mar 2006
Location: Lake Ray Hubbard
Posts: 845
Likes: 0
Received 0 Likes
on
0 Posts
Where do I find the "2 bolts" that are supposed to release the harness? On otger diagrams and pics of later model sc4's these bolts are located on top of the rear water bypass...mine are not. I'm not sure if it is a design nuance with mine being a 92 with a 91 build date, but these bolts are nowhere to be found. To this point everything has been straight-forward,mif time consuming, but this issue has caused what I expected to be a 6-8 hour project to now run into its 3rd day. Can anyone offer any insight?
04-04-13, 05:45 PM
#6
Where do I find the "2 bolts" that are supposed to release the harness? On otger diagrams and pics of later model sc4's these bolts are located on top of the rear water bypass...mine are not. I'm not sure if it is a design nuance with mine being a 92 with a 91 build date, but these bolts are nowhere to be found. To this point everything has been straight-forward,mif time consuming, but this issue has caused what I expected to be a 6-8 hour project to now run into its 3rd day. Can anyone offer any insight?
Good Luck!
Thread
Thread Starter
Forum
Replies
Last Post
