mattjk

iTrader: (1)

Trying to decide on the Treadstone TR1235 ( Core Size, 12.5" X 22" X 3.5")
or
Core Size, 10.5" X 22" X 3.5" (TR1035)

Seems like the top of the intercooler will be blocked by the bumper beam (no airflow), which I do not want to remove. Should I just go for the 10.5" high?

My goal is 550rwhp.

Thanks

Luxor

iTrader: (15)

Just mount the intercooler behind the bumper support. There is plenty of room behind there.

INTIMAZY

iTrader: (5)

There is actually a fair amount of air flow up higher because of our massive mechanical propeller of death. I say go with the taller one and mount it like Luxor said. Heat soaking is usually a bigger problem when not moving so bigger is better in my book until you get up to speeds where the air pressure from the bumper exceeds the flow of the fan.

mattjk

iTrader: (1)

Thanks you two. I'll go for the taller intercooler.

Halon

iTrader: (6)

+1 on the taller one. Here's my 24" x 12" x 4" core mounted for reference sake if it helps you at all.

mattjk

iTrader: (1)

What intercooler is that? thanks

already ordered up a treadstone cast manifold and tial mv-s wastegate. haven't decided on which comp billet turbo to run though.

Halon

iTrader: (6)

EBay special.

mattjk

iTrader: (1)

Will a 5 inch thick core fit behind the bumper beam? Thanks

Halon

iTrader: (6)

It might, but holy jeebus do you really need a 5" core? I made 630hp on my last car with a 3" core...

mattjk

iTrader: (1)

no, but I ordered the 3.5" core... was informed it was back ordered for 6 weeks so they upgraded me to the 4.5" core at no extra charge so I accepted.